Project Setup

Steps to setup the project on the system.

Step 1 - Pick the Skeleton(Starter Template)

In order to setup the project, pick any starter template from the Wieldy folder (one you got after purchasing the Wieldy), copy it to the place where you want to keep the project, rename the folder.

Step 2 - Installing the Dependencies

In step 2, Open the command prompt and reach out to the path where the folder is kept. Now, run the following command to install the dependencies and libraries used in Jumbo:-


Alternatively, you can open the folder in the development editor of your choice and run the above-written command in its terminal.

Step 3 - Running the project on Local Server

After installing the dependencies, you can run the project on the local server by using the following command:-

yarn start

Step 4 - Preparing the Build of the Project (Optional)

The build is used for presenting the offline demo of the project or putting the project on a live server. So this step is not mandatory if you want to run the project on localhost or in development mode.

To prepare the build of the project, run the following command:-

yarn build

The project was built assuming it is hosted at /. You can control this with the homepage field in your package.json.

The build folder is ready to be deployed. You may serve it with a static server:

yarn global add serve -s build

Find out more about deployment here:

Last updated